Automatic glass sand automatic sandblasting machine

2018-08-01 22:36:22 Stelle Group

Congratulations to our company for customizing the new automatic glass sand automatic sandblasting machine of mobile phone shell for OPPO

Automatic glass sand automatic sandblasting machine consists of three parts: automatic feeding machine, automatic sandblasting machine, and automatic cropping machine.

Firstly, two groups of Tray disks can be automatically exchanged by the automatic feeder. Tray disk needs to be placed on the LD Port manually.

After the Tray disk is positioned, the mechanical arm starts to take one piece and the glass is arrayed.

. Then, the glass is placed on the carrier Stg directly by the mechanical Arm and then sent to the blasting equipment.

When one Tray port is fetched, an alarm will informs the operator to load a new Tray disk. When the empty Tray disk is full, the device will automatically inform the operator to take the empty Tray disk away, and then perform a cyclical action.

When it comes to fully automatic water glass sand blasting machine, after artificially self-provisioning a certain proportion of water and sand, the equipment will automatically carry out mixing and stirring. The hook of an automatic feeding machine will grab the glass and put it on the conveying timing belt, and then the glass will enter the blasting machine cavity to be blasting. After the sand blasting operation is finished, the glass will be sent to be spraying by the water jets, and to be blow-dry by the air knife after the spraying.

After drying, the object is moved to the transplanting position of the cropping machine, and the glass is grabbed to the cutting machine FORK by the mechanical arm for recycling.

sandblasting, cleaning and drying. The areas have ribs to prevent the workpiece from displacing.

Finally, the automatic cropping machine will be accompanied by two sets of CST ports that can automatically exchange, then it requires the operator to empty the CST to the UnLD Port. After the CST is turned over 90°, the cylinder is mechanically positioned. The transplanting arm removes the glass from the fixture and places it on the Fork. The substrate in the CST, CST Port is placed on the top layer using the Fork method. After Fork vacuum sensor sensor/glass fiber sensor OFF, Fork automatically returns to the waiting position, which is in circulation. When the CST is full, the device will alert the operator to take the CST and load it into the empty CST.